Finisher installed
< 4 steps in all >
Open the cover.
Grasp the punch waste box handle, gently pull out the box, and discard the punch waste.
Discard the punch waste in a plastic bag or other container, taking care not to let the waste scatter.
Gently push the box back in.
Close the cover.
Finisher (large stacker) installed
< 4 steps in all >
Open the front cover of the punch module.
Pull out the punch waste box and discard the punch waste.
Discard the punch waste in a plastic bag or other container, taking care not to let the waste scatter.
Replace the punch waste box.
If the punch waste box is not replaced properly, printing will not be possible using the punch function.
Close the cover of the punch module.
Saddle finisher installed
< 4 steps in all >
Open the front cover.
Pull out the punch waste box and discard the punch waste.
Discard the punch waste in a plastic bag or other container, taking care not to let the waste scatter.
Replace the punch waste box.
Close the front cover.
Saddle finisher (large stacker) installed
<4 steps in all>
Open the front cover of the punch module.

punch-open_sf4k.jpg
Pull out the punch waste box and discard the punch waste.
Discard the punch waste in a plastic bag or other container, taking care not to let the waste scatter.

S-finisher(4K)-punch_pull.jpg

punch-trash_sdl.jpg(※ちゃんとイラストが置き換わっているか特に注意)
Replace the punch waste box.
If the punch waste box is not replaced properly, printing will not be possible using the punch function.

S-finisher(4K)-punch_back.jpg
Close the cover of the punch module.

punch-close_sf4k.jpg