OPERATIONS COMMON TO ALL MODES
FINISHER (LARGE STACKER)
This device outputs sorted paper while staggering each set of paper. As needed, it staples each set.
To punch holes in printed paper, install an optional hole punch module.
To punch holes in printed paper, install an optional hole punch module.
Function names
Staple compiler
This temporarily stacks paper to be stapled.
This temporarily stacks paper to be stapled.
Output tray (upper tray, lower tray)
Stapled and offset output is delivered to this tray.
The tray is slidable. Extend the tray for printing on large-size paper (12" x 18", 11" x 17", 8-1/2" x 14", 8-1/2" x 13", A3W, A3 and B4 sizes).
Stapled and offset output is delivered to this tray.
The tray is slidable. Extend the tray for printing on large-size paper (12" x 18", 11" x 17", 8-1/2" x 14", 8-1/2" x 13", A3W, A3 and B4 sizes).
Top cover
Open this cover to remove a paper misfeed.
Open this cover to remove a paper misfeed.
Front cover
Open this cover to replace the staple cartridge or remove a staple jam.
Open this cover to replace the staple cartridge or remove a staple jam.
New.jpg)
- A paper pass unit is required to install a finisher (large stacker) as well as a stand/1x500/2x500 sheet paper drawer.
- Do not place heavy objects on the finisher (large stacker) or press down on the finisher (large stacker).
- A finisher (large stacker) cannot be installed simultaneously with a finisher, saddle finisher or saddle finisher (large stacker).
- Exercise caution when you turn on the power and when printing is taking place, as the output tray may move up and down.
Supplies
The finisher (large stacker) requires the following staple cartridge:
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
AR-SC2
Staple cartridge (approx. 5000 staples per cartridge x three cartridges)
AR-SC2
_staple.jpg)
Finisher (large stacker) maintenance
When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the operation procedure to replace the staple cartridge.