This function collectively stores various settings as one program. The stored program can be retrieved using an easy operation.
For example, suppose that the same 8-1/2" x 11" (A4) size documents are distributed to branch offices in various regions once a month.
  1. (1)The same documents are faxed to each branch office
  2. (2)To save paper, two document pages are faxed as a single page
  3. (3)Smudges on the edges of the documents are erased before transmission
When a job program is not stored When a job program is stored
Enter the fax number for each branch.

Specify 2in1.

Specify Erase.

Tap the [Start] key.
Scan and send the original.
Call the registered program.

Tap the [Start] key.
Scan and send the original.
Considerable time is required to send the documents each month because the above settings must be selected.
In addition, mistakes are occasionally made when selecting the settings.		 When a program is stored, settings are selected with ease by simply tapping the key of the program.
In addition, transmission takes place according to the stored settings so there are no chances for mistakes.
To configure a program:
Tap the [Store Program - Set Current Store] key that appears on the action panel when you operate any mode screens.
  • The settings stored in a program will be retained even after the program is used for transmission. The same settings can be used repeatedly for transmission.
  • The following contents cannot be stored in programs:
    • Tapping the [Speaker] key, Custom Size, Card Shot, page move and unspecified erase during preview, Metadata Entry, Send Settings, and Own Name Select.
  • Up to 48 programs can be stored.
  • Up to 500 destinations can be stored in one program.
  • A program in which sub addresses and passcodes are specified as an F-code destination records all sub addresses and passcodes.