| Message | Description |
|---|---|
| OK | The transaction was completed normally. |
| G3 | Communication took place in G3 mode. |
| ECM | Communication took place in G3 ECM mode. |
| SG3 | Communication took place in Super G3 mode. |
| Forwarding | The received data was forwarded. |
| NO RESPONSE | No response from the receiving party. |
| BUSY | Transmission was not possible because the other party was already using the line. |
| CANCEL | The transmission was canceled while in progress. |
| MEMORY OVER | The memory became full during quick on-line transmission. |
| MEM. FULL | The memory became full during reception. |
| LENGTH OVER | The transmitted fax was over 59" (1.5 m) long and therefore could not be received. |
| ORIGINAL ERROR | Direct transmission or manual transmission was not successful because a misfeed occurred. |
| PASS# NG | The connection was broken because the polling passcode was not correct. |
| NO RX POLL | The machine that was polled does not have a polling function. |
| RX POLL FAIL | The other machine refused the polling operation, or your machine broke the connection when polled because no data was in memory. |
| NO F-CODE POLL | The other machine refused an F-code polling operation, or your machine broke the connection when polled because no data was in its F-code memory polling box. |
| RX POLL# NG | The connection was broken because the sub-address for F-code polling memory was not valid. |
| F POLL PASS# NG | The connection was broken because the passcode for F-code polling memory was not valid. |
| BOX NO. NG | Your machine broke the connection because the specified sub-address for an F-code memory box does not exist. |
| F PASS# NG | Your machine broke the connection because the other machine sent an incorrect passcode for F-code communication. |
| RX NO F-CODE POLL | F-code polling was attempted, however, the other machine did not have an F-code polling memory box. |
| NO F FUNC | F-code communication was attempted, however, the other machine does not support F-code communication. |
| NO F-CODE | F-code communication was refused by the other machine because of an incorrect sub-address or other reason. |
| M. BOX: [xxxxxx] ****** | Data was received and stored in a confidential or relay broadcast memory box, or data was sent from a memory polling box. The name of the memory box appears in [xxxxxx], and the type of F-code operation (relay request reception, polling memory transmission, or confidential reception) appears in ******. |
| FAIL xx (xxxx) | The transaction failed due to a communication error. First 2 digits of communication error number: Error code from 00 to 99. Last 4 digits of communication error number: Code for use by service technicians. |
| Reject Reception | A fax was sent from a party from which reception is blocked. |