Open the cover.
While pressing the lever over to the left, slide the finisher to the left until it stops.
Gently slide the finisher until it stops.
Lower the staple case release lever and remove the staple case.
Pull the staple case out to the right.
Raise the lever at the front end of the staple case and remove the jammed staple.
Remove the leading staple if it is bent. If bent staples remain, a staple jam will occur again.
Take care that a bent staple does not hurt you.
Lower the lever at the front end of the staple case.
Replace the staple case.
Push the staple case in until it clicks into place.
Slide the finisher back to the right.
Gently slide the finisher back to the right until it locks into its original position.
Close the cover.