LARGE CAPACITY TRAYS

Overview

Use the large capacity trays for outputting massive prints that cannot be processed using the regular tray.
The large capacity trays store a maximum of 5,000 sheets of paper (2,500 sheets for tray 5 and 2,500 sheets for tray 6) from 12" × 18"(A3W) to 7-1/4" × 10-1/2"R(B5R).
When changing the paper size, contact your dealer or "SHARP Service Department".
  • Other than plain paper, special media such as tab paper and transparency film can be loaded into the large capacity trays.
    To load tab paper, the dedicated guide must be installed.
  • If you loaded paper of a different type from the paper previously loaded, be sure to check the settings in "Setting mode".
To check the type of paper to be set in the tray:
In "Setting mode", select [System Settings] → [Paper Tray Settings].
Do not place heavy objects on the tray or press down on the tray.

Operation

  1. 2

    Press the operation button

    The operation button blinks, and the tray paper table goes down to the paper loading position. Wait until the operation button light goes off.

    Do not pull out the tray until the light goes off. If you pull out the tray forcibly while the button lights up or blinks, a machine failure may be resulted.

  2. Pull out the paper tray

    Gently pull the tray out until it stops.

  3. Load the paper

    Load the paper with the print side facing down. The stack must not be higher than the indicator line (maximum of 2,500 sheets).

    Fan the paper well before loading it. If the paper is not fanned, multiple sheets may feed at once and cause a misfeed.

  4. Gently push the paper tray into the machine

    Push the tray firmly all the way into the machine. The paper table goes up after the tray is pushed in.
    The operation button blinks while the paper table goes up. The button lights up when the paper table has gone up.

Loading the tab paper

  1. 2

    Remove the tab paper guide

    The guide is stored in the left side of the tray.

  2. 2

    Insert the tab paper into the tray

    Place the tab paper with the print side facing down so that the tab is to the right.

    See the following figure and adjust the tab position of the tab paper.
  3. 2

    Place the tab paper guide

    Place the guide on the top of the tab paper.

  4. 2

    Gently push the tray into the machine, and set the paper type to tab paper

    Using "Paper Tray Settings" in the system settings, set the paper type to tab paper.
    To set the paper type to tab paper:
    In "Setting mode", select [System Settings] → [Paper Tray Settings].
Back to top