OUTPUT SETTINGS

Overview

Configure the output settings for copies using Sort, Group, Offset, Staple, Punch, or Fold. Also specify the output destination of copies.

Output Tray

Specify the destination to output copies.
Select the output tray from [Offset Tray] and [Right Tray]. If a finisher (100-sheet stapling) or saddle finisher (100-sheet stapling) is installed, you can select the [Offset Tray], [Middle Tray] or [Right Tray].
If a finisher or saddle finisher is not installed, you can select the [Center Tray] or [Right Tray] key.

Offset

This function outputs copies while shifting them set by set. Setting the checkbox to icon enables the offset function, and setting it to icon disables the function.
This function is available only when the finisher or saddle finisher is installed.
Selecting the staple function clears the Offset checkmark automatically.

Sort/Group/Staple

Select the sorting method when copying the scanned original.
"Sort" sorts the scanned original on a set basis, and outputs them. "Group" sorts the scanned original on a page basis, and outputs them.
Each set of copies can be stapled, or the sheets can be folded at the center and stapled.
  • The staple function is available only when the finisher or saddle finisher is installed.
  • The saddle stitch function is available only when the saddle finisher is installed.

Fold•Punch

Copies can be folded or punched, and output.
  • The fold function is available only when the saddle finisher or folding unit is installed.
  • The punch function is available only when the punch module is installed.
Back to top