SADDLE STITCHING FOR SORTED COPIES

Overview

This function staples each set of copies at two positions in the center of paper, folds them in half, and outputs them. For saddle folding, it trims a side drop, offering a good-looking output image.

  • You can view staple positions in "DISPLAYING THE COPY PREVIEW".
  • A saddle finisher is required to use the saddle stitch function.
  • The trimmer function is available when a trimmer module is installed on the machine.

Operation

Saddle stitch

  1. 2

    Tap the [Output] key

  2. 2

    Tap the [Staple] tab, and tap the [Saddle Stitch] key

  3. 2

    Tap the [On] key

    After the settings are completed, tap icon.

    If the number of scanned originals exceeds the staple sheet limit, a message is displayed. Tap the [Divide], [Continue], or [Cancel] key.
    [Divide]: Divides the pages into sets that can be stapled and sorts them. You cannot use this function if the cover settings are selected.
    [Continue]: Continues sorting without stapling.
    [Cancel]: Cancels the staple sort setting.
    To cancel the Saddle Stitch:
    Tap the [Off] key.

Trimmer Setting

  1. 2

    When Saddle Stitch is selected, tap the [Trimmer Setting] key

  2. 2

    Tap the [On] key, and specify the trimming width

    Tap the numeric value display field of the trimming width, and enter the allowable range using the numeric keys. Otherwise, tap icon.
    After the settings are completed, tap icon.

    To cancel the Trimmer Setting:
    Tap the [Off] key.
Back to top