PUNCH MODULE (MX-PN12B)

Overview

The punch module can be installed on a finisher or saddle finisher to punch holes in paper to be output.
A finisher or saddle finisher is required to install the punch module.

Discarding punch waste

Punch waste from punched holes is collected in the punch waste box.
Follow the operation procedure to replace punch waste.

  1. Open the front cover

  2. Grasp the punch waste box handle, gently pull out the box, and discard the punch waste

    Discard the punch waste in a plastic bag or other container, taking care not to let the waste scatter.

  3. Gently push the box back in

  4. Close the front cover

Back to top