WIRELESS SETTINGS

It provides access to a network via a wireless LAN.
Clicking the [Submit] button stores the settings.

Wireless Settings

Used to enable or disable the wireless LAN and show the status of wireless LAN.

Connection Type Switching

Switches between infrastructure mode and access point mode to match the wireless LAN environment that is used.

Current Setting

Shows settings, such as the SSID of a wireless LAN and security type. If the wireless LAN is disabled, "--" appears.

Current Wireless Status

This shows reception levels (Max. 100) of the wireless LAN and IP addresses.

Show Wireless Setting Screen

Click the [Setup] button.
In the Wireless Setting screen, you can configure the SSID of a wireless LAN, Security Type, Encry., and Security Key.

Initialize Wireless Settings

Click the [Initialize] button.
The settings for SSID, Security Type, Encry., and Security Key are initialized.

Wireless Setting screen (Access Point Mode)

If the [Settings] button is clicked while [Connection Type Switching] is set to [Wired+Wireless (Access Point Mode)] or [Wired Only], the Wireless Settings (Access Point Mode) screen is displayed.

Configure the SSID of a wireless LAN, Security Type, Encry., and Security Key.
Clicking the [Submit] button stores the settings.

SSID

Enter an SSID using up to 32 characters.

Security Type

Select a security type.

Encry.

Select an encryption type.

Security Key

Enter a security key.

Security Type	Security Key
WEP 64bit	5 characters or 10-digit hexadecimal number
WEP 128bit	13 characters or 26-digit hexadecimal number
WAP/WAP2	8 to 63 characters or 64-digit hexadecimal number

Show Security Key

If it is set to ON, the security key appears.

Device IP Address

Enter the IP address.

Channel to Be Used

Select the channel to be used in wireless LAN.

Sending Output

Configure the sending output.

Bandwidth

Use this setting when the communication mode is "11n". Select the bandwidth to be used.

IP Address Distribution Range Setting

Configure the range to be used the IP address.

Wireless Setting screen (Infrastructure Mode)

If [Connection Type Switching] is set to [Wireless (infrastructure mode)] and the [Settings] button is clicked, the infrastructure mode wireless setting screen is displayed.
Configure the SSID, Security Type, Encry., and Security Key of a wireless LAN.
Clicking the [Submit] button stores the settings.

Access Point Search

Click this to search access points.
When the search results are displayed, select the access point to use and click [OK]. [SSID], [Security Type], and [Encry.] are automatically applied.