IMAGE ROTATION DOES NOT TAKE PLACE
If you are unable to solve a problem using the solutions in this manual, press the [Power] button and then turn the main power switch to the "
"position. Wait at least 10 seconds and then turn the main power switch to the "
"position. After the main power indicator color changes to green, press the [POWER] button.
"position. Wait at least 10 seconds and then turn the main power switch to the ""position. After the main power indicator color changes to green, press the [POWER] button.
When the background color of the job status display at the upper right corner of the touch panel is not gray, do not switch off the main power switch or unplug the power plug. This may damage the hard drive or cause the data being stored or received to be lost.
| Point to check | Solution |
|---|---|
| Did you select the copy ratio manually? | Copy using automatic ratio selection. |
| Are you copying using settings that do not allow rotate copying? | Rotate copying can generally be combined with other modes as required, however, some combinations are not possible. If a prohibited combination is selected, a message will appear in the touch panel. |
| Is "Rotation Copy Setting" disabled in the setting mode? | Check with your administrator. If you are the administrator, enable [Rotation Copy Setting]. Select [System Settings] → [Copy Settings] → [Rotation Copy Setting] → [Rotation Copy] in "Setting mode". |