A DESTINATION IS PRE-SELECTED
If you are unable to solve a problem using the solutions in this manual, press the [Power] button and then turn the main power switch to the "
"position. Wait at least 10 seconds and then turn the main power switch to the "
"position. After the main power indicator color changes to green, press the [POWER] button.
"position. Wait at least 10 seconds and then turn the main power switch to the ""position. After the main power indicator color changes to green, press the [POWER] button.
When the background color of the job status display at the upper right corner of the touch panel is not gray, do not switch off the main power switch or unplug the power plug. This may damage the hard drive or cause the data being stored or received to be lost.
| Point to check | Solution |
|---|---|
| Is [Default Address Setting] enabled in the setting mode? | If you wish to send to a destination other than the default destination, tap the [Cancel] key. If you are the administrator and wish to change or disable the default destination, change the settings as appropriate in [Default Address Setting]. "Setting mode" → [System Settings] → [Image Send Settings] → [Scan Settings] → [Default Address] → [Default Address Setting] |