When you set the Offset check box to , you can output the sorted paper sheets while shifting them set by set. You can easily remove each set from the output tray.
To change the output tray, tap the [Output Tray] key, and select the output destination.
If the number of scanned originals exceeds the staple sheet limit, a message is displayed. Tap the [Continue] or [Cancel] key. [Continue]: Continues sorting without stapling. [Cancel]: Cancels the staple sort setting.
After the settings are completed, tap and check that the [Pamphlet Copy] key is enabled on the staple sort screen. After you have checked it, tap .
If [Pamphlet Copy] is already specified in [Others>>], you do not need configure binding edge and cover settings.
If [Pamphlet Copy] is specified in [Others>>], the saddle stitch screen appears.
Confirm the message shown on the screen, and tap the [On] key.
Selecting the Offset check box outputs the sorted paper sheets while shifting them set by set to enable the user to easily remove each set from the output tray.
To change the output tray, tap the [Output Tray] key, and select the output destination.
If the number of scanned originals exceeds the staple sheet limit, a message is displayed. Tap the [Divide], [Continue] or [Cancel] key. [Divide]: Divides the pages into sets that can be stapled and sorts them. You cannot use this function if the cover settings are selected. [Continue]: Continues sorting without stapling. [Cancel]: Cancels the staple sort setting.