Place the original in the document feeder tray of the automatic document feeder.
Multiple originals can be placed in the document feeder tray. The stack of originals must not be higher than the indicator line on the tray.
Originals can also be placed on the document glass.
Enter the destination fax number.
Tap the [Job Build] key.
A checkmark appears on the icon.
To cancel the Job Build setting:
Tap the [Job Build] key to clear the checkmark.
Tap the [Start] key to scan the first set.
Tap the [Preview] key to check the preview of an image before sending a fax. For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED".
Place the next set of originals and tap the [Start] key.
To cancel scanning the original:
Tap the [STOP] key.
Tap the [Read-End] key.
  • If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the transmission is reserved.
  • The [Change Setting] key can be tapped to change the exposure, resolution, scan size, and send size for each original page scanned. However, when Job Build is used in combination with "2in1" in "Others", only the exposure can be changed when scanning each even-numbered page of the original pages.