DOCUMENT GLASS

Overview

This section describes the steps to set the original on the document glass.
  • Close the automatic document feeder slowly. Abruptly closing the automatic document feeder may damage it.
  • Exercise care that your fingers are not pinched when closing the automatic document feeder.

Maximum original size allowed

Standard sizes
11" (longitudinal) × 17" (transversal)
297 mm (longitudinal) × 420 mm (transversal)
Non-standard size
11-5/8" (longitudinal) × 17" (transversal)
297 mm (longitudinal) × 432 mm (transversal)
When the original is a non-standard size, see the appropriate explanation below for the mode you are using.

Operation

  1. 2

    Open the automatic document feeder

  2. 2

    Place the original

    Place the original with the scan side facing down.
    Align the top left corner of the original with back left (at the tip of the mark ) of the document glass.

    When placing a non-standard size original on the document glass, the size can be detected easily by placing a blank sheet of 8-1/2" × 11" (A4), 5-1/2" × 8-1/2" (B5), or other standard size paper on top of the original.
  3. 2

    Close the automatic document feeder

    If the automatic document feeder is left open while copying, parts outside of the original will be copied in black, causing excessive use of toner.
Back to top