Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
Enter the destination fax number.
Tap the [Others >>] key, and tap the [2in1] key.
A checkmark appears on the icon.
To cancel the 2in1 setting:
Tap the [2in1] key to clear the checkmark.
After the settings are completed, tap the [<< Back] key.
Tap the [Original] key.
Tap the [Image Orientation] key with the same orientation as the placed original.
If this setting is not correct, a suitable image may not be transmitted.
After the settings are completed, tap .
04067002.jpg
Tap the [Start] key to start scanning of the original.
Tap the [Preview] key to check the preview of an image before sending a fax. For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED".
  • If you inserted the original pages in the document feeder tray, all pages are scanned.
    A beep will sound to indicate that scanning and transmission have ended.
  • If you placed the original on the document glass, scan each page one at a time.
    When scanning finishes, place the next original and tap the [Start] key. Repeat the procedure until all pages have been scanned and then tap the [Read-End] key.
    A beep will sound to indicate that scanning and transmission have ended.
Tap the [Change Setting] key in the scan-end confirmation screen to change the exposure, resolution, scan size, and send size.
(However, when scanning each even-numbered page of the original, only the exposure can be changed.)