First, to place the machine in a desired image send mode, tap the appropriate icon in the Home screen.
1 Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
2. Enter the destination.
Tap the address key to directly enter the destination, and specify the address to send scan data.
050170001.jpg
3. Configure the scan settings.
Specify the original scan size, exposure, file format, and other items.
If necessary, you can refer to the following functions for the setting.
For other settings, see the contents of Image Send.
050170002.jpg
4. Set Others.
Use Others other than the time when using scan settings such as sending two pages as a single page or sending originals of different sizes at the same time.
050170003.jpg
5. Send the original.
Tap the [Start] key.
You can check the preview of an image by tapping the [Preview] key.
When the original is placed on the document glass:
Repeat the placing original and transmission procedures until all originals have been sent. After scanning all originals, tap the [Read-End] key.