Place originals in the automatic document feeder.
The original can also be placed on the document glass.
Specify the destination.
Tap the [Job Build] key.
A checkmark appears on the icon.
To cancel the Job Build setting:
Tap the [Job Build] key to clear the checkmark.
Tap the [Start] key to scan the first set.
Tap the [Preview] key to check the preview of an image before sending a fax. For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED". However, settings for this function cannot be changed in the preview screen.
Place the next set of originals and tap the [Start] key.
To cancel scanning the original:
Tap ([STOP] key). All scanned data will be cleared.
Tap the [Read-End] key.
  • If no action is taken for one minute after the confirmation screen is displayed, scanning automatically ends and the transmission is reserved.
  • The [Change Setting] key can be tapped to change the exposure, resolution, scan size, and send size for each original page scanned. However, when Job Build is used in combination with "2in1" in "Others", only the exposure can be changed when scanning each even-numbered page of the original pages.