USING THE DOCUMENT GLASS TO SEND A FAX IN DIRECT TX MODE

Overview

Sending a scanned original without saving it in the machine's memory is called "Direct TX".
This section explains how to scan the original placed on the document glass and directly send data.
When sending a fax from the document glass in direct transmission mode, only one page can be transmitted.
  • The following functions cannot be used with direct transmission:
    Timer Transmission, 2in1, Card Shot, Job Build, Polling Memory, Original Count, File, Quick File, Memory Box, Book Divide, Poling, 2-Sided Scan, Search Global Address Book
  • Resending will not take place when a direct transmission is not successful due to a communication error or other reason.
  • In direct transmission mode,you cannot use the [Preview] key.
Do not place any objects under the original size detector located at the back of document glass. Closing the automatic document feeder while an object is underneath it may damage the original size detector plate and prevent correct detection of the document size.
For the location of original size detector, see "UPPER SIDE".

Operation

  1. Placing Originals on the Document Glass

  2. Tap the [Send Directly] key on the action panel

  3. Specify the destination fax number

    • Only one destination can be specified. A one-touch key in which multiple destinations are stored cannot be used.
    • The destination cannot be retrieved from a global address book.
  4. Tap the [Start] key

    When the line has been connected to the destination, scanning of the original starts.
    If a fax transmission is already in progress when the direct transmission operation is performed, the direct transmission will wait until the previous transmission is finished. When the previous transmission is completed, the direct transmission will begin.
    While the direct transmission is waiting, you can only check the job status.
    To cancel scanning the original:
    Tap the [Cancel Scan] key.
Back to top