TEMPORARILY CHANGE SENDER INFORMATION (OWN NAME SELECT)

Overview

The function is released when the transmission with the changed sender information ends.

To store the sender information to be used for Own Name Select function:

In "Setting mode (administrator)", select [System Settings] → [Image Send Settings] → [Operation Settings] → [Own Name and Destination Set] → [Registration of Own Name Select].

Operation

1. 

   Place the original

   Place the original in the automatic document feeder or on the document glass.

   • AUTOMATIC DOCUMENT FEEDER
   • DOCUMENT GLASS
2. 

   Enter the destination fax number

   • ENTERING A DESTINATION NUMBER USING THE NUMERIC KEYS
   • SPECIFYING A DESTINATION FROM THE ADDRESS BOOK
   • SPECIFYING A DESTINATION USING THE SEARCH NUMBER
   • SPECIFYING A DESTINATION FROM THE GLOBAL ADDRESS BOOK
   • SPECIFYING A DESTINATION FROM TRANSMISSION LOG
3. 

   Tap the [Others] key, and tap the [Own Name Select] key
4. 

   Tap the Sender Data key, and specify the sender information to be used for Own Number Setting

   After the settings are completed, tap and [Back] keys in sequence.

   

   

   To cancel the sender information setting:

   Tap the [Clear] key.
5. 

   Tap the [Start] key to start scanning of the original

   If you inserted the original pages in the document feeder tray, all pages are scanned.
   When you place the original on the document glass, scan each page one at a time.
   After you have scanned the last original, tap the [Read-End] key.
   A beep will sound to indicate that scanning and transmission have ended.

   Tap the [Preview] key to preview the output image before sending it. After you have scanned an original by tapping the [Preview] key, tap the [Additional Scan] key to scan the next original. Tap the [Start] key to start sending an image.
   For more information, see "CHECKING THE OUTPUT IMAGE BEFORE TRANSMISSION".