INSERTING INSERTION SHEETS IN BETWEEN TRANSPARENCY FILMS (TRANSPARENCY INSERTS)
Overview
When copying on transparency film, the sheets may stick together due to static electricity.
The transparency inserts function can be used to insert a sheet of paper between each sheet of transparency film, making the sheets easy to handle.
It is also possible to copy on insertion sheets.
The transparency inserts function can be used to insert a sheet of paper between each sheet of transparency film, making the sheets easy to handle.
It is also possible to copy on insertion sheets.
- When performing 2-sided copying, only "2-Side to 1-Side" mode can be used.
- Transparency film can be loaded in the bypass tray, tray 4 and large capacity trays.
The number of copies cannot be selected in this mode.
Operation
-
Load transparency film in the bypass tray, tray 4 or large capacity trays
When using the bypass tray, place the paper with the print side up. -
Set the tray
-
Place an original, and tap the [Preview] key
Place the original in the automatic document feeder or on the document glass. -
Tap the [Others] key, and then tap the [Transparency Inserts] key
-
Tap the [On] key
When making a copy on insertion sheets, tap the [Also Make Copy on Inserts] checkbox to set to .
After the settings are completed, tap and the [Back] key in sequence.To cancel the transparency inserts setting:
Tap the [Off] key. -
Check the preview image in the preview screen
To cancel all settings:
Tap the [CA] key. -
Tap the [Start] key to start copying