TEMPORARILY CHANGING THE SENDER INFORMATION(OWN NAME SELECT)
Overview
You can temporarily change sender information to be used in the own number sending by selecting from data stored separately.
![](../images/ic_Memo.png)
![](../images/ic_System.png)
To store the sender information to be used for Own Name Select function:
In "Setting mode (administrator)", select [System Settings] → [Image Send Settings] → [Operation Settings] → [Own Name and Destination Set] → [Registration of Own Name Select].Operation
![](../images/step_01.jpg)
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
![](../images/step_02.jpg)
![](../images/step_03.jpg)
![](../images/step_04.jpg)
After the settings are completed, tap
.
![](./icon/tp_closekey.jpg)
![](../images/ic_Limit.png)
Tap the [Clear] key.
![](./panel/04076001.jpg)
![](../images/step_05.jpg)
- If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning has ended, and the machine stands by for transmission. - If you placed the original on the document glass, scan each page one at a time.
When scanning finishes, place the next original and tap the [Start] key. Repeat until all pages have been scanned and then tap the [Read-End] key.
A beep will sound to indicate that scanning has ended, and the machine stands by for transmission.
![](../images/ic_Memo.png)
For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED".