ENHANCING THE OUTLINE OF THE SCANNED ORIGINAL BEFORE TRANSMISSION(SHARPNESS)

Overview

This function cannot be used in Internet fax mode.

Operation

Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
Specify the destination.
Tap the [Others] key, and tap the [Sharpness] key.
Tap or slide the slider to adjust the sharpness.
To cancel the sharpness settings:
Tap the [Off] key.
After the settings are completed, tap and [Back] keys in sequence.
Tap the [Start] key to start scanning of the original.
Tap the [Preview] key to check the preview of an image before sending a fax. For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED". However, settings for this function cannot be changed in the preview screen.
  • If you inserted the original pages in the document feeder tray, all pages are scanned.
    A beep will sound to indicate that scanning and transmission have ended.
  • If you placed the original on the document glass, scan each page one at a time.
    When scanning finishes, place the next original and tap the [Start] key. Repeat the procedure until all pages have been scanned and then tap the [Read-End] key.
    A beep will sound to indicate that scanning and transmission have ended.
Back to top