SENDING TWO PAGES AS A SINGLE PAGE(2IN1)

Overview

Reduce two original pages to the equal size and sent them as a single page. This function is convenient when you have a large number of original pages and wish to reduce the number of pages sent.

For the standard size (8-1/2" x 11" (A4) or 5-1/2" x 8-1/2" (B5 or A5)), original pages are scanned from both the single pass feeder and document glass.
  • This function cannot be used in scan mode or data entry mode.
  • The 2in1 is only available for originals with a size other than a standard size ( 8-1/2" x 11" (A4) or 5-1/2" x 8-1/2" (B5 or A5)).
  • Transmission is not possible at a size smaller than the original size.
  • When the scan size of the original is specified by numeric values, this function cannot be used.
  • This function cannot be used together with Dual Page Scan or Card Shot.

Operation

Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
Specify the destination.
Tap the [Others] key, and tap the [2in1] key.
A checkmark appears on the icon.
After the settings are completed, tap the [Back] key.
To cancel the 2in1 setting:
Tap the [2in1] key to clear the checkmark.
Tap the [Original] key.
Tap the [Image Orientation] key with the same orientation as the placed original.
If this setting is not correct, a suitable image may not be transmitted.
After the settings are completed, tap .
Tap the [Start] key to start scanning of the original.
Tap the [Preview] key to check the preview of an image before sending a fax. For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED".
  • If you inserted the original pages in the document feeder tray, all pages are scanned.
    A beep will sound to indicate that scanning and transmission have ended.
  • If you placed the original on the document glass, scan each page one at a time.
    When scanning finishes, place the next original and tap the [Start] key. Repeat the procedure until all pages have been scanned and then tap the [Read-End] key.
    A beep will sound to indicate that scanning and transmission have ended.
Tap the [Change Setting] key in the scan-end confirmation screen to change the exposure, resolution, scan size, and send size. (However, when scanning each even-numbered page of the original, only the exposure is changed.)
Back to top