FAX TRANSMISSION SEQUENCE

First, tap the [Fax] icon on the home screen to enter fax mode.
Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
Enter the destination fax number.
Tap the numeric keys to enter the destination number directly, or search and retrieve the address book or number.
Configure the scan settings.
Specify the original scan size, exposure, resolution, etc.
If necessary, you can refer to the following functions for the setting.
Set Others.
Use Others other than the time when using scan settings such as sending two pages as a single page or sending originals of different sizes at the same time.
Send the original.
Tap the [Start] key.
  • You can check the preview image by tapping the [Preview] key before tapping the [Start] key. After you have scanned an original by tapping the [Preview] key, tap the [Additional Scan] key to scan the next original.
  • If you tap the [File] key or [Quick File] key on the action panel before starting fax transmission, you can save the scanned original as data.
When the original is placed on the document glass:
  • If you placed the original on the document glass, carry out the following procedure to send a fax.
    • When sending a fax normally (memory transmission)
      Repeat the steps for placing and scanning the originals the same number of times as there are originals. After scanning all originals, tap the [Read-End] key. (After you have scanned an original by tapping the [Preview] key, tap the [Additional Scan] key to scan the next original. Then, tap the [Start] key to send the original.)
    • When sending a fax in direct transmission mode
      Multi-page originals cannot be scanned in direct transmission mode. Tap the [Start] key to start transmission.
  • When sending a fax in direct transmission mode
    Multiple originals cannot be scanned in direct transmission mode. Tap the [Start] key to start transmission.
Back to top